Baldwin 1045-I 4-1/2" x 4-1/2" Solid Brass Plain Bearing Square Corner Hinge

Priced per hinge

FEATURES: Extruded brass, full mortise hinges are machined for precise installation and smooth movement. Knuckles are milled to a clearance of .010˝ (.25mm) to
minimize vertical wear. Each hinge is beveled on the inside leaf to obtain a tight fit when viewing the hinge in a closed position, and furnished with stainless steel,
rust-proof pins for added durability.

PIN DESIGN: Each pin is manufactured from precision ground Type 302, stainless steel material to prevent corrosion. The pin “floats” within the barrel of the hinge, yet
is held in a stationary position. Pins can be removed by unthreading each finial and tapping the pin upward from the bottom of the barrel.

FINIAL DESIGN: Hinge finials are specially designed to thread into the top and bottom of the hinge barrel, preventing the pin from rising out of the hinge barrel. All tips
are completely interchangeable to facilitate stocking and eliminate excessive inventories. Finials can be purchased separately in sets of four only. Hinges are furnished
standard with button design finials.

FASTENERS: All full mortise hinges are supplied standard with appropriate size wood screws as noted on chart. Wood screws are fully threaded to the head and have
an undercut head for secure installations.

BEVELED EDGE: Each Baldwin hinge is beveled on the inside leaf to obtain a tight fit when the hinge is in a closed position.

EXTRUSION: Hinges manufactured from solid brass extrusions have two inherent properties: exceptional strength and precision tolerances. Baldwin’s extruded hinges
are machined from a solid brass bar to exact tolerances to ensure an even wear between each knuckle. The result is a QUALITY hinge which can withstand above average
door weights and stresses with maximum vertical and lateral wear performance.

TEMPLATE: All full mortise hinges illustrated within this section are designed in accordance with the most current specifications established by the American National
Standards Institute (ANSI).

APPLICATION: Baldwin full mortise hinges are classified as STANDARD WEIGHT for installation on doors up to 1.75˝ (44mm) in thickness. For further details on applications,
Consult Hinge Chart.

NUMBER OF HINGES: Use three hinges on doors up to and including 7.5 feet (2.3m) and one additional hinge for each additional 2.5 feet (.76m) or fraction thereof.

IMPORTANT: Baldwin Hinges are extruded from the finest quality brass and individually machined to close tolerances. The leaves from each half pair are NOT INTERCHANGEABLE with those of any other half pair. To ensure smooth operation and prevent binding, DO NOT MIX hinge leaves during installation.